2.3 Display
The screen shows various menus, dialogues and displays as
described below.
There are basically six types of screen:
• Standby (clock)
• Splash (mode)
• Now playing
• Dialogue
• Error/Information
• Menu
When text is too long to fit on the screen, it is first shown truncated,
then after a few seconds, slowly scrolls so that you can read it all.
The Standby screen shows the time, date and any active alarm
times.
As you cycle through the play modes using SOURCE, DR3 shows a
splash screen for each mode. After one second, DR3 enters the
selected mode and tries to start playing the last station or track that
was playing in that mode. If this is not possible, DR3 tries to connect
to the selected source by scanning for stations, or prompting for
user input as appropriate.
Now playing screens show information about the audio source and
track now playing, where available.
Dialogue screens are shown to allow the user to change settings.
Error/Information screens give specific messages for a few seconds,
then change automatically to another screen.
Menus
DR3 has basically three types of menu. Use the Select control to
step through and select options. A scroll bar on the right of the
screen shows if there are further options above or
below those visible.
Each mode has a Mode menu, with options specific to that mode.
Below for DAB mode menu as an example.
System settings >.The '>' indicates options leading to further menus.
The System settings menu allows access to system settings
and information such as time, language and software update.
Menus with more options than will fit on one screen have a ">"in the
right.
Some menus, for example the System settings menu, have several
submenus.
3. Started and setup
DR3 is easy to use. To play DAB or FM radio, all you need is a power
source (a 100-240 V mains supply);
1). Place DR3 on a suitable shelf or table.
2). Extend the telescopic antenna.
3). Connect the power adaptor between DR3 and the mains supply.
3.1 12/24 hour display
To change between 12 and 24 hour display, select Set 12/24 hour
and then select your preference.
3.2 Time/date
The time and date can be updated manually or automatically.
65
To Next Page
Loading...
Need help?
General
