: 5W
Model: DTS2
Type: Clock Radio & Charger
Drivers: 1 x 2.5"
Power output: RMS 3W
Wireless charging output
Power Supply: DC 5V 3A
or 3.7V/8800mA/H lithium batteries
Dimensions: L 205 X H60 X D205 MM
Weight: 775g
SPECIFICATIONS
Specifications are subject to change without notice.
Any Changes or modifications not expressly approved by
the party responsible for compliance could void the
user's authority to operate the equipment. This device
complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received,
including interference that may cause undesired
operation.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and
receiver.
-Connect the equipment into an outlet on a circuit
different
from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV
technician for help.
9
8
To Next Page
Loading...
Need help?
General
