The first time you select DAB radio mode, Or if the station list is empty,
MSY5automatically performs a full scan to see what stations are available. You may
also need to start a scan manually to update the list of stations for one of the following
reasons:
Available stations change from time to time.
If reception was not good for the original scan (for example the antenna was not up),this
may result in an empty or incomplete list of available stations.
If you have poor reception of some stations (burbling), you may wish to list only stations
with good signal strength.
To start a scan manually, select M
enu > Scan.
Once the scan is complete, the radio shows a list of available stations.
To remove stations that are listed but unavailable, select M
enu > Prune invalid.
6
.2 Selecting stations
To listen to or change a station, turn the Select control to view a list of stations and
press to select. Once selected, the station plays and the screen shows information
about the station, track or show as broadcast.
P
resets
To store a DAB preset, press and hold Pres set until the display shows the Save preset
screen.
Sel
ect one of the 20 presets (on the remote) to save the currently playing station.
To select a preset, press P
res set briefly, then select one of the listed preset stations.
When a preset station is playing, it shows
1,2,3 etc in the bottom middle of the
screen.
6
.3 Now playing information
22
To Next Page
Loading...
Need help?
General
