EasyManua.ls Logo

LENCO BT-125 - Important Safety Instructions; General Safety Precautions

LENCO BT-125
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Important safety instructions
When used in the directed manner, this unit has been designed and manufactured to ensure
your personal safety. However, improper use can result in potential electrical shock or re
hazards. Please read all safety and operating instructions carefully before installation and use,
and keep these instructions handy for future reference. Take special note of all warnings listed in
these instructions and on the unit.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Water and Moisture
The unit should not be used near water. For example: near a bathtub, washbowl, kitchen
sink, laundry tub, swimming pool or in a set basement.
Ventilation
The unit should be situated so that its location or position does not interfere with its proper
ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that
may block the ventilation openings. The ventilation should not be impeded by covering the
ventilation openings with items, such as newspapers, table-cloths, curtains, etc. Also, it
should not be placed in a built-in installation, such as a bookcase or cabinet, which may
impede the ow of air through the ventilation openings; minimum distances 30 cm around
the apparatus for sufcient ventilations.
Heat & ame
The unit should be situated away from heat sources such as radiators, heat registers,
stoves or other appliances (including ampliers) that produce heat.
No naked ame sources, such as lighted candles, should be placed on the apparatus.
Power source
The unit should be connected to a power supply only of the type described in the operating
instructions or as marked on the appliance. Where the AC mains power cord is used as the
disconnect device, the disconnect device shall remain readily operable.
Power cord protection
Power supply cords should be routed so that they are not likely to be walked on or pinched
by items placed upon or against them. It is always best to have a clear area from where the
cord exits the unit to where it is plugged into an AC outlet.
Cleaning
The unit should be cleaned only as recommended. See the section “Care and Mainte-
nance” of this manual for cleaning instructions.
Object and liquid entry
Care should be taken so that objects do not fall and liquids are not spilled into any open-
ings or vents located on the unit. It shall not be exposed to dripping or splashing and that
no objects lled with liquids, such as vases, shall be placed on the apparatus.
Attachments
Do not use attachments no recommended by the product manufacturer.
Lightning and power surge protection
Unplug the unit from the wall outlet and disconnect the periods of time. This will prevent
damage to the product due to lightning and power-line surges.
Overloading
Do not overload wall outlets, extension cords, or integral convenience receptacles as this
can result in a risk of re of electric shock.
Damage requiring service
This unit should be serviced by qualied service personnel when:
A. Objects have fallen into or liquid has been spilled into the enclosure.
B. The unit has been exposed to rain.
C. The unit has been dropped or the enclosure damaged.
D. The unit exhibits a marked change in performance or does not operate normally.
GB / 英文
GB 2

Related product manuals