LENCO BT-191 - Page 8

E. Auto reconnect with paired device
1. Every me you turn On the Bluetooth Speaker’s power; it will firstly
searching for the mobile device which has been paired previously and
and sll in record;
2. The Bluetooth Speaker will reconnect this mobile device as priority if
it is in the Bluetooth searching device mode and in the
connecon range.
3. If no device found in some seconds, then the Bluetooth
Speaker will
automacally turn into the pairing mode.
4. Now you can process for new mobile device pair.
F. Use NFC for fast Bluetooth pairing
in blue from slowly blinking.
4. Now, you can process for new mobile device pair or power Off the
Bluetooth Speaker if you wanted.
5. Noce: even disconnected Bluetooth for long me but it will be
reconnected when you come back to use this speaker.
a. On Bluetooth Speaker:
1. Turn on the unit
2. Make sure that the NFC detecon mark “NFC (4)” is at the right place
to touch.
b. On Mobile Phone:
1. Make sure that the mobile phone has the NFC funcon turned on
and the screen is acve (unlocked).
2. Touch the mobile device NFC sensor on the Bluetooth Speaker’s NFC
detecon mark. Keep touching unl the mobile device vibrates and
or sound. (When the devices connect, some mobile phone may pop
up a dialog box to confirm on it screen)
3. Aer pairing is successful; from Bluetooth speaker, a tones will
sound and the “Bluetooth(10)” LED will blink slowly in Blue
4. To disconnect the Bluetooth Speaker from an NFC connected phone,
touch it with the mobile device again.
Hint: If you cannot connect the unit, try the following:
• Move the mobile phone slowly over the “NFC” mark of the Bluetooth
Speaker.
• If the mobile phone is in case (especially metal), remove it from the
case.
7