Daylight Saving and Leap Year Adju
stments
All Daylight Saving and Leap Year adjustments are made automatically by
the SmartSet
®
internal computer as follows:
Start of Daylight Saving Time:
At 1:59.59 AM on the
last
Sunday of daylight saving time, the clock
will automatically advance to 3
:00 AM.
End of Daylight Saving Time:
At 2:59.59 AM on the last Sunday of daylight saving time, the clock will
automatically reset to 2:00 AM.
Leap Year:
At 12:00 Midnight on February 28th, the calendar display will change
to 29
.2
.
Manual Time Adjus
tments
Some people like to set their clocks 5 to 10 minutes fast to make sure that they will
always be on time. Even though the SmartSet
®
sets the time by itself, you still have
the option of adjusting the time manually if you wish.
To manually adjust the time display depress and hold the
TIME
button, and press
either the
SET
(Up) or (Down) buttons to adjust the time display ahead or
back as desired.
Each press of the
SET
(Up) or (Down) buttons will change the display by one
minute. If you hold the
SET
(Up) or (Down) buttons the display will continue
to change. The display will change slowly at first, one minute at a time. But if you
continue holding the
SET
(Up) or (Down) buttons the display will change
rapidly.
NOTE:
If you manually adjust the time, your n
ew setting is entered into the
SmartSet
®
memory. If the power is interrupted, the display will return to your
new setting, not the original setting, when the power is restored.
Adjusting The Wake Up Times
Your SmartSet
®
clock radio has two separate alarms
that can be set and used
independently. You may use the alarms to wake two people at different times, or
you may use one alarm for weekdays and the other for weekend wake up times.
The procedure for adjusting the wake up time is the same for both Alarm 1
and
Alarm 2.
1.) Depress and hold either the
ALARM 1
or
ALARM 2
setting button.
The respective Alarm 1 or Alarm 2 time, and DAY OF WEEK indicators will
appear.
2.) While holding the
ALARM 1
or
ALARM 2
setting button, depress either the
SET
(Up) or (Do
wn) button to move the alarm display ahead or back to
your respective Alarm 1 or Alarm 2 desired wake up time.
3.) When the desired wake up time appears on the display, release the
SET
(Up) or (Down) buttons.
4.) When the desired wake up time appears on t
he display, release
the
ALARM 1
or
ALARM 2
setting buttons.
To Next Page
Loading...
