LENCO CR-333 - Wake to RADIO

FM The FM antenna is built in to the AC power cord. If FM reception is weak try
varying the position and direction of the power cord until you find the strongest
signal.
Wake To RADIO
1.) Turn the radio On and select the Band, Station, and Volum e level that you
wish to hear when the alarm comes on, then turn the radio Off again.
2.) Reconfirm the wake up time and alarm mode settings for the alarm you are
using, Alarm 1, Alarm 2, or both Alarms.
3.) Set the ALARM selector switch for one or both alarms to the RADIO position.
The appropriate ALARM 1 and/or ALARM 2 display will change from OFF to
the selected wake up time.
4.) At the selected wake up time the radio will turn On . It will play for one hour and
then shut off automatically.
5.) To stop the radio sooner, press either the appropriate ALARM 1 or ALARM 2
button, or press the RADIO ON/OFF button. The radio will stop but the alarm
remains set and will turn the radio on again at the same time on the following
day (depending on the Alarm M ode setting).
6.) If you do not want the alarm to turn the radio on the following day, set the
appropriate ALARM selector to the OFF position. The respective alarm display
will show OFF .