LENCO PA-80 User Manual

SPECIFICATIONS
Input Voltage: AC 100-120V/ 60Hz 220-240V/ 50Hz
POWER CONSUMPTION:70 WATTS
Frequency Response: 70Hz~ 50kHz +/- 3dB
Produce dimensions:350x428.5x245.5mm(wxhxd)
Bottom pole mount specifications: Standard Pole Mount found at professional audio retailer:
Depth 80mm (3.15”)
Diameter 35.5mm (1.40”)
Time required to fully charge the: under 4 hours
Battery life: Over 12 hours* at full volume of full volume of the when fully charged.
“Note: Battery life may vary based on temperature, age, and volume usage of product.
IMPORTANT NOTES
Input is clipping: Try lowering the input gain or the volume control on your sound source or music
instrument.
Output is clipping: Lower the main volume level.
There is too much bass: Try adjusting the tone or EQ control on your sound source to lower the
bass level. this will allow you to play the music louder before clipping (distortion) occurs.
The link cable: is being plugged into the instrument or MIC input instead of the RCA line input.
Use this troubleshooting guide if: The sound is distorted at high volumes.
Important: With all large speakers, initial "break-in" period is needed to perform at optimal levels.
To properly "break-in" your, play an audio source at medium volume for a few hours.
If at any time in the future you should need to dispose of this product please
note that:Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist.Check with your Local Authority or retailer for
recycling advice.(Waste Electrical and Electronic Equipment Directive)
The product before disassembling product keep on , turn
off the power switch.
Uninstalled all fixed screw back, remove retaining plate,
please open negative (-), then
open court since the positive (+), remove the battery
replacement court since,
replacement battery, please confirm battery position
installed correctly, put fixed plate and
tighten the screw securing plate fixation plate, until the
motionless, but don't screw it too
tight.
The waste battery
Battery can not be recycle. However, the battery is
dangerous. You should seek dealer or
local organs of qualified opinion processing waste
storage battery.
BATTERY DISASSEMBLING

LENCO PA-80 Specifications

Power

input voltage	AC 100-120V/ 60Hz 220-240V/ 50Hz
power consumption	70 WATTS

Battery

time required to fully charge	under 4 hours
battery life	over 12 hours

Audio Specifications

frequency response	70Hz~ 50kHz +/- 3dB

Weight and Dimensions

produce dimensions	350x428.5x245.5mm (wxhxd)
bottom pole mount depth	80mm (3.15”)
bottom pole mount diameter	35.5mm (1.40”)