14
MODIFY UNIT PARAMETERS
ºC 0,1
ºC 0,1
ºC 0,1
--- 1
---
1
ºC 0,1
ºC 0,1
ºC 0,1
Num 1
ºC 1
--- 1
ºC
1
Num 1
--- 1
--- 1
--- 1
--- 1
--- 1
ºC 1
ºC 1
ºC 0,1
ºC 0,1
Num 1
Num 1
ºC 1
Num 1
--- 1
Num 1
--- 1
ºC 0,1
ºC 0,1
Num 1
Num 1
ºC 1
MIN MAX
2 CIRCUITS UNIT MODEL Climatic
®
400
DESCRIPTION
DEF UNID. VAR.
St4 configuration
Balancing of the circuits
Serial output configuration
Dynamic set point enable
Ext. temperature in cool Dynamic set point
Ext. temperature in heat Dynamic set point
Ext. temperature cool Dynamic set point differential
Family serial address
Heating thermal regulator hysteresis
Cooling thermal regulator hysteresis
Steps delta
0 25,5 1.5
0 25,5 1.5
0 25,5 1.5
Compressors activation sequence
0 1 0
Alarm relay polarity
Ext. temperature heat Dynamic set point differential
0 1
0
---
1
Unit for temperature measure
Device serial address
Internal antifrost heater set point in heat
MIN MAX
1 CIRCUIT UNIT MODEL Climatic
®
200
DESCRIPTION
DEF UNIT VAR.
Serial output configuration
St4 configuration (if digital)
Operation mode selection
Unit for temperature measure
0 1 0
Dynamic set point enable
Ext. temperature in cool Dynamic set point
Ext. temperature in heat Dynamic set point
Ext. temperature cool Dynamic set point differential
Ext. temperature heat Dynamic set point differential
Family serial address
Device serial address
Alarm output polarity
Internal antifrost heater set point in heat
Heating thermal regulator hysteresis
Cooling thermal regulator hysteresis
Steps delta
0 25,5 1.5
0 25,5 1.5
0 25,5 1.5
St4 configuration
0 3
127 35
0 1 0
1 48 35
0 3 0
0 1 0
0 1 0
0 1 0
0 1 0
0 1 0
-127 127 35
-127
127 6
-50,0 80,0 -10,0
0 14 0
0 14 0
1 48 35
0 6
0 1 0
0 2 0
0 1 0
-127
-12,7 12,7 -10,0
-12,7 12,7 6,0
0 14 0
0 14 0
127 6,0-127
-50,0 80,0 6,0
0: no probe / 2: remote changeover S./W. / 3: outdoor temp.
3: remote changeover Summer/Winter.
0: selection by keyboard / 1: selection by digital input
0: no enable / 1: enable
0: temp. on ºC / 1: temp. on ºF
0: open relay if the output is on
1: closed relay if the output is on
0: depending on operating hours
1: starting sequence
0: open relay if the output is on
1: closed relay if the output is on
0: saturation of the circuits
1: balanced circuits
0: no probe / 3: outdoor temperature
0: no enable / 1: enable
0: temp. on ºC / 1: temp. on ºF
Operation mode selection
0: selection by keyboard / 1: selection by digital input