EasyManua.ls Logo

Lennox EL180UH070E36B User Manual

Lennox EL180UH070E36B
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Page 1
© 2013 Lennox Industries Inc.
EL180UHE(X)
Service Literature
Corp. 1302-L1
Revised 06-2013
EL180UHE(X) series units are mid-efficiency gas furnaces
used for upflow or horizontal applications only, manufac
tured with Lennox Duralokt heat exchangers formed of
aluminized steel. EL180UHE(X) units are available in heat
ing capacities of 44,000 to 132,000 Btuh and cooling ap
plications 2 to 5 tons. Refer to Engineering Handbook for
proper sizing.
Units are factory equipped for use with natural gas. Kits are
available for conversion to LP/Propane operation.
EL180UHE(X) model units are equipped with a hot surface
ignition system. The EL180UHE(X) unit meets the Califor
nia Nitrogen Oxides (NO
x
) Standards and California Sea
sonal Efficiency requirements. All units use a redundant
gas valve to assure safety shut-off as required by C.S.A.
All specifications in this manual are subject to change. Pro
cedures outlined in this manual are presented as a recom
mendation only and do not supersede or replace local or
state codes. In the absence of local or state codes, the
guidelines and procedures outlined in this manual (except
where noted) are recommended only and do not constitute
code.
TABLE OF CONTENTS
Specifications Page 2.............................
Blower Data Page 4..............................
Parts Identification Page 6.........................
I Unit Components Page 7........................
II Installation Page 20.............................
III Start Up Page 20..............................
IV Heating System Service Checks Page 20.........
V Typical Operating Characteristics Page 25.........
VI Maintenance Page 25..........................
VII Wiring and Sequence of Operation Page 28......
WARNING
Improper installation, adjustment, alteration, service
or maintenance can cause property damage, person
al injury or loss of life. Installation and service must
be performed by a licensed professional HVAC in
staller (or equivalent), service agency or the gas sup
plier.
WARNING
Electric shock hazard. Can cause injury
or death. Before attempting to perform
any service or maintenance, turn the
electrical power to unit OFF at discon
nect switch(es). Unit may have multiple
power supplies.
WARNING
Sharp edges.
Be careful when servicing unit to avoid sharp edges
which may result in personal injury.
Question and Answer IconNeed help?

Do you have a question about the Lennox EL180UH070E36B and is the answer not in the manual?

Lennox EL180UH070E36B Specifications

General IconGeneral
BrandLennox
ModelEL180UH070E36B
CategoryFurnace
LanguageEnglish

Summary

Unit Overview and Safety

General Safety Warnings

Essential safety precautions for installation, service, and operation.

Unit Specifications

Unit Components

Integrated Control and Electronic Ignition

Details the integrated control module and its electronic ignition system.

Troubleshooting and Diagnostics

Diagnostic Codes and LED Indicators

Lists LED flash codes and corresponding diagnostic codes for troubleshooting.

Heating System Components

Measuring Flame Signal

Instructions for checking the flame signal using a microamp meter.

Ignitor Checks and Testing

Outlines procedures for testing ignitor resistance and voltage.

Blower Motor Service

Replacing the Motor Module

Details the process for replacing the motor control module and testing.

Installation and Operation

Heating System Service Checks

Typical Operating Characteristics

Maintenance Procedures

Wiring and Sequence of Operation

Schematic Diagram and Operational Flow

Provides the wiring schematic and step-by-step heating operation sequence.

Troubleshooting Guide

Heating Sequence Troubleshooting

Flowcharts to diagnose issues based on the heating sequence of operation.

Cooling Sequence Troubleshooting

Flowcharts to diagnose issues based on the cooling sequence of operation.

Related product manuals