Placing Furnace In Operation
1 - Set thermostat to lowest setting.
2 -
3 - This appliance is equipped with an ignition device
which automatically lights the burner. Do not try to
light the burner by hand.
4 - Open or remove the heat section access panel.
Turn gas valve switch to “OFF”. Do not force.
6 -
STOP! Immediately call your gas
to the next step.
Turn gas valve switch to “ON”. Do not force.
8 - Close or replace the heat section access panel.
9 - Turn on all electrical power to appliance.
Set thermostat to desired setting.
11 - The combustion air inducer will start. The burners
12 -
before locking out.
13 -
14 -
your service technician or gas supplier.
1 -
lowest setting.
2 -
power to the appliance.
3 - Open or remove the heat section access panel.
4 -
D-Safety or Emergency Shutdown
valves.
WHITE RODGERS 36H54 GAS VALVE
Two-Stage
GAS VALVE SWITCH SHOWN IN ON POSITION.
Inlet Pressure Tap
Outlet Pressure
Tap
High Fire Adjustment
(under cap)
Low Fire Adjustment
(under cap)
FIGURE 24
To Next Page
Loading...
Need help?
General
