To Next PageTo Next PageHow to resolve low temperature lockout on Lennox Air Conditioner?
To resolve a low-temperature lockout on your Lennox Air Conditioner's outdoor unit, increase the ambient temperature around the unit.
How to troubleshoot IPM error on Lennox MWMA012S4-*P Air Conditioner inverter module?
To troubleshoot an IPM error on your Lennox Air Conditioner's inverter module, examine the inverter module and replace it if necessary.
What to do if my Lennox MWMA012S4-*P shows an indoor return air temperature sensor error?
If your Lennox Air Conditioner indicates an indoor return air temperature sensor error, examine the sensor and its connections.
How to fix indoor coil temperature sensor error in Lennox MWMA012S4-*P Air Conditioner?
To address an indoor coil temperature sensor error in your Lennox Air Conditioner, check temperature sensor functionality.
How to troubleshoot outdoor ambient temperature sensor error on Lennox MWMA012S4-*P Air Conditioner?
To troubleshoot an outdoor ambient temperature sensor error on your Lennox Air Conditioner, test the sensor for accuracy and replace it if necessary.
What to do if my Lennox MWMA012S4-*P Air Conditioner has an outdoor coil temperature sensor error?
If your Lennox Air Conditioner shows an outdoor coil temperature sensor error, inspect and verify the sensor's condition.
General| Cooling Capacity (BTU/hr) | 12, 000 |
|---|---|
| EER | 11.5 |
| Voltage (V) | 208/230 |
| Phase | 1 |
| Hertz (Hz) | 60 |
| Refrigerant | R-410A |
Specifies the required clearances around single-zone outdoor units for proper ventilation and service access.
Specifies the required clearances for M22A, M33A, and M33B cassette indoor units.
Specifies required clearances for MCFA and MCFB ceiling/floor indoor units.
Details limitations for refrigerant pipe length and elevation for single-zone systems.
Instructions and diagrams for correctly installing indoor unit gravity drain lines.
Details requirements for condensate piping when using an indoor unit lift pump.
Instructions for adding refrigerant to single-zone systems based on pipe length.
Explains how to check compressor windings resistance for shorts and terminal identification.
Details the procedure to measure resistance across IPM terminals for testing.
