GUIDE SPECIFICATIONS
SPB − 3 to 5 Ton R−410A Heat Pump Outdoor Units / Page 18
PART 2.02 PRODUCT SUBSTITUTIONS
A. Substitutions: No substitutions permitted.
PART 3 EXECUTION
PART 3.01 MANUFACTURER’S INSTRUCTIONS
Specifier Note: Revise article below to suit project requirements and specifier’s practice.
A. Compliance: Comply with manufacturer’s written data, including product technical bulletins, product catalog installation
instructions and product carton installation instructions.
PART 3.02 EXAMINATION
A. Site Verification of Conditions: Verify that substrate conditions, which have been previously installed under other sections,
are acceptable for product installation in accordance with manufacturer’s instructions.
PART 3.03 INSTALLATION
A. Install heat pump in accordance with manufacturer’s instructions and regulations of authorities having jurisdiction.
END OF SECTION
To Next Page
Loading...
