Chapter 2. 2-3
Adjusting your monitor image
This section describes the control features to adjust your monitor image.
Using the direct access controls
The direct access controls can be used when the On-Screen Display (OSD) is not displayed.
Icon Control Description
1
Switches the video input source
Input Source
Press and hold for 10 seconds to enable or disable the
Direct access to Mode Switch
DDC-CI
Mode Switch
DDC-CI function
Exit Exit and return to previous level
2
Decrease/Up
Up browsing key
For increasing the value on adjustment bar/tune in
Press to move to previous item
3
Brightness Direct access to Brightness adjustment
Down browsing key
Increase/Down For decreasing the value on adjustment bar/tune in
Press to move to next item
4
Menu
To access OSD menu
Press to confirm selection
Press and hold for 10 seconds will lock menu/un-
lock menu
Enter
Press to enter next level on main menu/sub menu
status or enter previous level on adjustment bar
Downloaded from www.vandenborre.be