Statement 17:
CAUTION:
The following label indicates moving parts nearby.
To remove a hot-swap power supply, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 73.
2. Disconnect the power cord from the power supply that is to be removed.
3. If you are replacing a power-supply1, press down on the orange release
latch2 and pull the power supply out of the bay, using the handle.
4. If you are instructed to return the power supply, follow all packaging instructions,
and use any packaging materials for shipping that are supplied to you.
Chapter 4. Removing and replacing server components 95
To Next Page
Loading...
Need help?
General