EasyManuals Logo

Lenovo ThinkServer RS110 Hardware Maintenance Manual

Lenovo ThinkServer RS110
254 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
Enabling the Serial ATA (SATA) controller: To enable the SATA RAID controller,
complete the following steps:
1. Turn on the server.
2. When the prompt Press F1 for Configuration/Setup appears, press F1. If you
have set an administrator password, you are prompted to type the password.
3. Select Devices and I/O Ports --> Advanced Chipset Control.
4. Select SATA Controller Mode Option. Change the value to Enhanced.
5. Scroll down and select SATA RAID Enable.
6. Select Enabled.
7. Press Esc; then, select Yes to save the changes.
Using the Adaptec RAID Configuration Utility program:
Note: Adaptec RAID (also known as HostRAID) is not supported on the SCO 6.0
and UnixWare 7.14 operating systems.
Use the Adaptec RAID Configuration Utility program to perform the following tasks:
v Configure a redundant array of independent disks (RAID) array
v View or change the RAID configuration and associated devices
For additional information about using the Adaptec RAID Configuration Utility
program, see the documentation on the IBM ServeRAID-8e (Adaptec HostRAID)
Support CD that comes with the server.
Adaptec RAID Configuration Utility menu choices: The following choices are on the
Adaptec RAID Configuration Utility menu:
v Array Configuration Utility
Select this choice to create, manage, or delete arrays, add or delete a hot-spare
drive, or initialize drives.
v SerialSelect Utility
Select this choice to configure the controller interface definitions or to configure
the physical transfer and SATA address of the selected drive.
v Disk Utilities
Select this choice to format a disk or verify the disk media. Select a device from
the list and read the instructions on the screen carefully before making a
selection.
Starting the Adaptec RAID Configuration Utility program: To start the Adaptec
RAID Configuration Utility program, complete the following steps:
1. Turn on the server.
2. When the prompt Press <CTRL><<A> for Adaptec RAID Configuration Utility
appears, press Ctrl+A.
3. To select a choice from the menu, use the arrow keys to highlight it and press
Enter.
Creating a RAID array: To use the Adaptec RAID Configuration Utility program to
configure a RAID level-1 array, complete the following steps:
1. Start the Adaptec RAID Configuration Utility program.
2. Select Array Configuration Utility.
3. Select Create Array.
Chapter 2. Configuration information and instructions 19

Table of Contents

Other manuals for Lenovo ThinkServer RS110

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lenovo ThinkServer RS110 and is the answer not in the manual?

Lenovo ThinkServer RS110 Specifications

General IconGeneral
BrandLenovo
ModelThinkServer RS110
CategoryServer
LanguageEnglish

Related product manuals