Important: The server might malfunction if these settings are incorrectly
configured. Follow the instructions on the screen carefully.
This choice is on the full Configuration/Setup Utility menu only.
– CPU Options
Select this choice to view or change the options that control the behavior of
the microprocessor.
– PCI Bus Control
Select this choice to view or change the system resources that are used by
the installed PCI or PCI-Express devices.
– RSA II Settings
This choice is displayed only when a Remote Supervisor Adapter II SlimLine
is installed in the server.
Select this choice to view the DHCP IP address and settings and the Remote
Supervisor Adapter II SlimLine MAC address; to view or change the DHCP
control, static IP address, operating-system USB selections; and to save the
values and reboot the Remote Supervisor Adapter II SlimLine.
– Baseboard Management Controller (BMC) Setting
Select this choice to change the Intelligent Platform Management Interface
(IPMI) settings for the mini-BMC controller.
- IPMI Specification Version
This nonselectable item displays the IPMI specification version.
- BMC Firmware Version
This nonselectable item displays the mini-BMC firmware version.
- BMC Build Date
This nonselectable item displays the date that the mini-BMC code was built.
- BMC Build Level
This nonselectable item displays the version of the mini-BMC code.
- Existing Event Log number
This nonselectable item displays the number of entries in the system-event
log.
- BMC POST Watchdog
This option enables or disables the POST watchdog. Disabled is the
default setting.
- BMC POST Watchdog Timeout
This option enables or disables the mini-BMC POST watchdog timer.
- System - BMC Serial Port Sharing
Select this choice to specify whether the serial port that the mini-BMC uses
is shared with the other system components or is dedicated to the
mini-BMC. When this option is enabled, the mini-BMC controls the serial
port by way of remote commands. If this option is disabled, the serial port
is assigned to the mini-BMC, unless the BMC Serial Port Access Mode
option is disabled.
- BMC Serial Port Access Mode
Select this choice to set the mini-BMC access mode for the system serial
port. Shared is the default setting. You can choose from the following
access modes:
64 ThinkServer TD100 and TD100x Types 4203, 4204, 4205, 4206, 6398, 6399, 6419, and 6429: User Guide
To Next Page
Loading...
Need help?
General