2.Iftheserverisinstalledinarackcabinet,removetheserverfromtherackcabinetandplaceitonaflat,
clean,andstatic-protectivesurface.SeetheRackInstallationInstructionsthatcomeswiththeserver.If
theserverisintowerformfactor,laytheserveronitssideforeasieroperation.
3.Removetheservercover.See“Removingtheservercover”onpage70.
4.Removeanypartsanddisconnectanycablesthatmightimpedeyouroperation.
5.LocatetheAnyRAIDadapter.See“Servercomponents”onpage26.
6.DisconnectallcablesfromtheAnyRAIDadapter.
7.Dooneofthefollowing:
•FortheAnyRAIDadapterwithoutanairduct,gotostep8.
•For3.5-inch-driveservermodelsthathaveanAnyRAIDadapterinstalledwithanairduct
Openthesmallhandle
1bygentlypressingdownthehandleslightlyandpullingthehandleoutward
toreleaseitfromthesecuredposition.Then,lifttheAnyRAID-adapterairductstraightupandout
ofthechassis.
Figure122.RemovingtheAnyRAID-adapterairductforservermodelswith3.5-inchdrives
Chapter6.Replacinghardware157