Lenovo ThinkServer TS440 70AL - Page 145

Beforeyoubegin,printalltherelatedinstructionsorensurethatyoucanviewthePDFversiononanother
computerforreference.
Notes:
•Thehot-swaphard-disk-drivebackplaneissensitivetoESD.Ensurethatyoureadandunderstand
“Handlingstatic-sensitivedevices”onpage66
firstandcarefullyperformtheoperation.
•Dependingonthemodel,yourservermightlookslightlydifferentfromtheillustrationsinthistopic.
Toreplacethehot-swaphard-disk-drivebackplane,dothefollowing:
1.Removeallmediafromthedrivesandturnoffallattacheddevicesandtheserver.Then,disconnectall
powercordsfromelectricaloutletsanddisconnectallcablesthatareconnectedtotheserver.
2.Removetheservercover.See“Removingtheservercover”onpage67.
3.Removethefrontbezel.See“Removingandreinstallingthefrontbezel”onpage69.
4.Locatethehot-swaphard-disk-drivebackplanes.See“Hot-swaphard-disk-drivebackplane”onpage
32
.
5.Removethefrontsystemfan1.See“Replacingthefrontsystemfan1”onpage144.
6.Removealltheinstalledhot-swapharddiskdrivesanddummytrays(ifany)fromthehard-disk-drive
cage.See“Installingorreplacingahot-swapharddiskdrive”onpage117
.
7.Recordthecableconnectionsonthebackplane,andthendisconnectallthecablesfromthebackplane.
8.Liftthereleaselatch1andslidethehard-disk-drivecageoutofthefrontofthechassis.
Note:Thefollowingillustrationshowsthe3.5-inchhard-disk-drivecage.Forthe2.5-inchhard-disk-drive
cage,theremovalprocedureisthesame.
Figure86.Removingthehard-disk-drivecage
Chapter6.Installing,removing,orreplacinghardware133