9.Dooneofthefollowing:
•Forthebackplaneforservermodelswith3.5-inchhard-disk-drivebays,removethefourscrewsthat
securethebackplane,andthenremovethebackplanefromthehard-disk-drivecage.
Figure87.Removingthebackplaneforservermodelswith3.5-inchhard-disk-drivebays
•Forthebackplaneforservermodelswith2.5-inchhard-disk-drivebays,removethesixscrewsor
threescrewsthatsecurethebackplanedependingonthetypeofthebackplane.Then,remove
thebackplanefromthehard-disk-drivecage.
Figure88.Removingthebackplaneforservermodelswith2.5-inchhard-disk-drivebays
10.Touchthestatic-protectivepackagethatcontainsthenewhot-swaphard-disk-drivebackplanetoany
unpaintedsurfaceontheoutsideoftheserver.Then,removethenewbackplanefromthepackage.
Note:Carefullyhandlethebackplanebyitsedges.
11.Positionthenewbackplaneonthehard-disk-drivecagesothatthescrewholesinthenewbackplane
arealignedwiththecorrespondingholesinthehard-disk-drivecage.Then,dooneofthefollowing
dependingonthehard-disk-drivecage:
134ThinkServerTS440HardwareMaintenanceManual
To Next Page
Loading...
