Install Rails to Rack
Notes: The graphic shown below is the right rail.
Use the same method to install the rails to all types of racks:
• For square-hole rack, use M5 screws and cage nuts
• For round-hole rack, use M5 screws and clip nuts
• For threaded rack, use only 10-32 or 12-24 screws (depending on the rack)
Step 1. Align the rail with the rack and install the screws to secure the front side of the rail.
Step 2. Adjust the rear sliding bracket against the rack; then, install the screws to secure the rail.
Step 3. Repeat step 1-2 on the left rail.
1 Screws installation on the front side of the rack
2 Screws installation on the rear side of the rack
88
To Next Page
Loading...
