Lenovo ThinkSystem SR250 - Page 14

Table 2. Events organized by severity (continued)
Event ID
Message String Severity
FQXSPEM4024I The RAID controller detected one or more possible configuration
problem within the subsystem. Please check the event logs and if
events are targeted to the same disk then replace the drive. If
necessary, contact technical support for additional assistance.([arg1],
[arg2],[arg3],[arg4],[arg5])
Informational
FQXSPEM4025I One or more virtual drive have problem. Please contact technical
support to resolve this issue.([arg1],[arg2],[arg3],[arg4],[arg5])
Informational
FQXSPEM4026I
Drive error was detected by RAID controller. Please contact technical
support to resolve this issue.([arg1],[arg2],[arg3],[arg4],[arg5])
Informational
FQXSPEM4027I Drive error was detected by RAID controller. Please check the event
logs and if events are targeted to the same disk then replace the drive.
If necessary, contact technical support for additional assistance.
([arg1],[arg2],[arg3],[arg4],[arg5])
Informational
FQXSPEM4028I The port [arg1] of PCIe device [arg2] at [arg3] has link [arg4]. Informational
FQXSPEM4029I All PCIe slots on [arg1] may not be functional based upon your current
CPU population.
Informational
FQXSPEM4030I
A scheduled operation on the RAID controller has encountered an
issue. Refer to RAID Logs under Server Management, Local Storage,
for details.([arg1],[arg2],[arg3],[arg4],[arg5])
Informational
FQXSPFC4000I
The bare metal connection process has been started. Informational
FQXSPFC4001I The bare metal update application reports a status of [arg1]. Informational
FQXSPFC4002I System running in setup. Informational
FQXSPFC4003I UEFI deployment boot mode is enabled for NextBoot. Informational
FQXSPFC4004I UEFI deployment boot mode is enabled for NextAc. Informational
FQXSPFC4005I UEFI deployment boot mode has been disabled. Informational
FQXSPFW0003I The System [ComputerSystemElementName] encountered firmware
progress.
Informational
FQXSPFW2000I The System [ComputerSystemElementName] has detected a POST
Error deassertion.
Informational
FQXSPFW2001I The System [ComputerSystemElementName] has detected a POST
Error deassertion.
Informational
FQXSPFW2002I The System [ComputerSystemElementName] has recovered from a
firmware hang.
Informational
FQXSPIO0000I The connector [PhysicalConnectorElementName] has been
connected.
Informational
FQXSPIO0010I A Correctable Bus Error has occurred on bus [SensorElementName]. Informational
FQXSPIO2001I The connector [PhysicalConnectorElementName] configuration error
has been repaired.
Informational
FQXSPIO2002I The System [ComputerSystemElementName] has detected a POST
Error deassertion.
Informational
FQXSPIO2003I System [ComputerSystemElementName] has recovered from a
diagnostic interrupt.
Informational
10 ThinkSystem SR250 Messages and Codes Reference