Lenovo ThinkSystem SR250 - Page 141

7. Contact Lenovo Support.
• FQXSFPU0034L: The TPM could not be initialized properly.
Severity: Error
User Action:
Complete the following steps:
1. Reboot the system. Reflash UEFI image.
2. If the problem persists, collect Service Data logs.
3. Contact Lenovo Support.
• FQXSFPU4033F: TPM Firmware recovery is in progress. Please DO NOT power off or reset system.
Severity: Warning
User Action:
Information only; no action is required.
Note: The system will not respond to power off signal (FQXSFPU4034I) while TPM firmware recovery in
progress.
• FQXSFPU4034I: TPM Firmware recovery is finished, rebooting system to take effect.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPU4035M: TPM Firmware recovery failed. TPM chip may be damaged.
Severity: Warning
User Action:
Complete the following steps:
1. Reboot the system.
2. If the error recurs TPM related features will not work.
3. If the problem persists, collect Service Data logs.
4. Contact Lenovo Support.
• FQXSFPU4038I: TPM Firmware recovery successful.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPU4040M: TPM selftest has failed.
Severity: Warning
User Action:
Complete the following steps:
1. Reboot the system.
2. If the error recurs TPM related features will not work.
3. If the problem persists, collect Service Data logs.
4. Contact Lenovo Support.
Chapter 3. UEFI events 137