Table 2. Events organized by severity (continued)
Event ID
Message String Severity
FQXSPPU0001N An Over-Temperature Condition has been detected on
[ProcessorElementName].
Error
FQXSPPU0007N CPU voltage mismatch detected on [ProcessorElementName].
Error
FQXSPPW0002L [PowerSupplyElementName] has Failed.
Error
FQXSPPW0007L [PowerSupplyElementName] has a Configuration Mismatch. Error
FQXSPPW0035M Numeric sensor [NumericSensorElementName] going low (lower
critical) has asserted.
Error
FQXSPPW0047M Numeric sensor [NumericSensorElementName] going high (upper
critical) has asserted.
Error
FQXSPPW0061M Sensor [SensorElementName] has transitioned to critical from a less
severe state.
Error
FQXSPPW0063M Sensor [SensorElementName] has transitioned to critical from a less
severe state.
Error
FQXSPPW0110M Non-redundant:Insufficient Resources for
[RedundancySetElementName] has asserted.
Error
FQXSPSB0000N The System [ComputerSystemElementName] has encountered a
motherboard failure.
Error
FQXSPSD0001L The [StorageVolumeElementName] has been disabled due to a
detected fault.
Error
FQXSPSD0005L Array [ComputerSystemElementName] is in critical condition. Error
FQXSPSD0006L Array [ComputerSystemElementName] has failed. Error
FQXSPSE4000I Certificate Authority [arg1] has detected a [arg2] Certificate Error. Error
FQXSPSR0001N Sensor [SensorElementName] has transitioned to non-recoverable
from a less severe state.
Error
FQXSPUN0019M Sensor [SensorElementName] has transitioned to critical from a less
severe state.
Error
FQXSPUN0023N Sensor [SensorElementName] has transitioned to non-recoverable.
Error
FQXSPUP0007L Invalid or Unsupported firmware or software was detected on system
[ComputerSystemElementName].
Error
FQXSPUP4000I Please ensure that the Management Controller [arg1] is flashed with
the correct firmware. The Management Controller is unable to match
its firmware to the server.
Error
FQXSPUP4003I [arg1] firmware mismatch internal to system [arg2]. Please attempt to
flash the [arg3] firmware.
Error
FQXSPUP4004I XCC firmware mismatch between nodes/servers [arg1] and [arg2].
Please attempt to flash the XCC firmware to the same level on all
nodes/servers.
Error
FQXSPUP4005I FPGA firmware mismatch between nodes/servers [arg1] and [arg2].
Please attempt to flash the FPGA firmware to the same level on all
nodes/servers.
Error
22 ThinkSystem SR250 Messages and Codes Reference
To Next Page
Loading...
