Lenovo ThinkSystem SR250 - Page 96

• FQXSPPW2006I: [PowerSupplyElementName] has returned to a Normal Input State.
This message is for the use case when an implementation has detected a Power Supply that has input
that has returned to normal.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0099
User Action:
Information only; no action is required
• FQXSPPW2007I: [PowerSupplyElementName] Configuration is OK.
This message is for the use case when an implementation when a Power Supply configuration is OK.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Power
SNMP Trap ID: 4
CIM Prefix: PLAT CIM ID: 0105
User Action:
Information only; no action is required.
• FQXSPPW2008I: [PowerSupplyElementName] has been turned on.
This message is for the use case when an implementation has detected a Power Unit that has been
Enabled.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Power On
SNMP Trap ID: 24
CIM Prefix: PLAT CIM ID: 0107
User Action:
Information only; no action is required.
• FQXSPPW2031I: Numeric sensor [NumericSensorElementName] going low (lower non-critical) has
deasserted.
This message is for the use case when an implementation has detected a Lower Non-critical sensor going
low has deasserted.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Warning - Voltage
SNMP Trap ID: 13
CIM Prefix: PLAT CIM ID: 0477
User Action:
Information only; no action is required
92
ThinkSystem SR250 Messages and Codes Reference