Server model with two 2.5-inch hot-swap rear drive bays and one PCIe slot
The following illustration shows the rear view of the server model with two hot-swap drive bays and one PCIe
slot. Depending on the model, your server might look slightly different from the illustration below.
Table 15. Components on the rear of the server
1 PCIe slot 1 on riser 1 assembly 2 Rear 2.5-inch drive bays (2)
3 Power supply 2 (optional)
4 Power supply 1
5 NMI button
6 VGA connector
7 USB 3.1 Gen 1 (5Gbps) connectors (3 DCIs) 8 XClarity Controller network connector
9 Ethernet connectors of the OCP module on the rear
(optional, two or four connectors may be available)
Note: For more information about each component, see
“Rear components overview” on page 27.
Server model with two 7mm hot-swap rear drive bays and two PCIe slots
The following illustration shows the rear view of the server model with two 7mm hot-swap rear drive bays and
two PCIe slots. Depending on the model, your server might look slightly different from the illustration below.
Table 16. Components on the rear of the server
1 PCIe slot 1 on riser 1 assembly 2 PCIe slot 2 on riser 1 assembly
3 Rear 7mm drive bays (2) 4 Power supply 2 (optional)
5 Power supply 1 6 NMI button
7 USB 3.1 Gen 1 (5Gbps) connectors (3 DCIs) 8 VGA connector
9 XClarity Controller network connector 10 Ethernet connectors of the OCP module on the rear
(optional, two or four connectors may be available)
Note: For more information about each component, see
“Rear components overview” on page 27.
Server model with two 7mm hot-swap rear drive bays and one PCIe slot
The following illustration shows the rear view of the server model with two 7mm hot-swap rear drive bays and
one PCIe slots. Depending on the model, your server might look slightly different from the illustration below.
26
ThinkSystem SR635 V3 System Configuration Guide
To Next Page
Loading...
