• FQXSFPU0033G: Processor has been disabled.
Severity: Warning
User Action:
Complete the following steps:
1. Check Lenovo support site for an applicable service bulletin or UEFI firmware update that applies to
this error.
2. Reboot the system.
3. If the problem persists, collect Service Data logs.
4. Contact Lenovo Support.
Service Action:
Complete the following steps:
1. Reviewe PD Steps.
2. Inspect all CPU sockets for damage.If CPU socket damaged replace the system board.
3. If there are multiple processors, swap affected processor with another processor from a different socket. If
problem follows the affected processor, or this is a single processor system, replace the processor.
4. If problem persists, escalate to next level support.
• FQXSFPU0034L: The TPM could not be initialized properly.
Severity: Error
User Action:
Complete the following steps:
1. Reboot the system. Reflash UEFI image.
2. If the problem persists, collect Service Data logs.
3. Contact Lenovo Support.
Service Action:
Complete the following steps:
1. Verify PD steps.
2. If the error persists, replace system board or the standard I/O book if applicable.
3. If problem persists, escalate to next level support.
• FQXSFPU0035N: A 3-strike timeout has occurred on processor [arg1].
Severity: Fatal
User Action:
Complete the following steps:
1. Check Lenovo support site for an applicable service bulletin or UEFI firmware update that applies to
this error.
2. Reboot the system.
3. Check and reverse any recent changes to system settings or the Operating System.
4. If the problem persists, collect Service Data logs.
5. Contact Lenovo Support.
Chapter 3. UEFI events 229