Lenovo ThinkSystem SR850 V2 - Page 254

• FQXPMCL0011K: Failed import bmc settings.
Severity: Warning
User Action:
1. Ensure BMC version is the same between source and target.
2. Restart BMC via supported method and reboot the system.
3. Perform AC reset or virtual reseat.
Note: When performing AC reset, after powering off AC, wait several seconds before powering on
AC. After AC power is restored, power on the host system.
4. Retry the import of BMC setting.
5. If the problem persists, please contact technical support.
Service Action:
1. Review PD Steps.
2. If problem persists, escalate to next level of support.
• FQXPMEM0001M: Unable to locate LXPM firmware image
Severity: Error
User Action:
1. Restart BMC via supported method and reboot the system.
2. Reflash the LXPM.
3. Perform AC reset or virtual reseat.
Note: When performing AC reset, after powering off AC, wait several seconds before powering on
AC. After AC power is restored, power on the host system.
4. If the problem persists, please contact technical support.
Service Action:
1. Review PD Steps.
2. Load the XCC settings to defaults.s.
3. Reflash XCC firmware.
4. If problem persists, escalate to next level of support
• FQXPMEM0002I: LXPM firmware image found. Starting LXPM
Severity: Info
User Action:
Information only; no action is required.
Service Action:
n/a
• FQXPMEM0003I: LXPM has exited. Control returned to UEFI
Severity: Info
250
ThinkSystem SR850 V2 System Events Service Guide