Please ensure bootable media be installed correctly.
Service Action:
Complete the following steps until the problem is solved:
1. Review PD Steps.
2. Check the Hard drive type is within system support configuration.
3. Make sure the bootable media is installed correctly.
4. Make sure UEFI boot mode is set correctly.
5. Make sure the boot device is set within UEFI boot sequence.
6. If problem persists, escalate to next level of support.
• FQXSPCA0002M: Numeric sensor [NumericSensorElementName] going low (lower critical) has
asserted.
This message is for the use case when an implementation has detected a Lower Critical sensor going low
has asserted.
Severity: Error
Serviceable: Yes
Automatically notify Support: No
Alert Category: Critical - Fan Failure
SNMP Trap ID: 11
CIM Prefix: PLAT CIM ID: 0480
User Action:
Complete the following steps:
1. Ensure fans are installed correctly.
2. If fan is installed with issue , please reinstall fan.
3. If the problem still exist, then please contact Lenovo support.
Service Action:
Complete the following steps until the problem is solved:
1. Review PD Steps and confirm that the fan has been reseated.
2. Replace the affected fan.
3. If problem persists, escalate to next level of support.
• FQXSPCA0007J: Numeric sensor [NumericSensorElementName] going high (upper non-critical)
has asserted.
This message is for the use case when an implementation has detected an Upper Non-critical sensor
going high has asserted.
Severity: Warning
Serviceable: Yes
Automatically notify Support: No
Alert Category: Warning - Temperature
SNMP Trap ID: 12
CIM Prefix: PLAT CIM ID: 0490
User Action:
Chapter 2. XClarity Controller events 27
To Next Page
Loading...
