Service Action:
Information only; no action is required.
• FQXSPCA2019I: Sensor [SensorElementName] has deasserted the transition to non-recoverable
from a less severe state.
This message is for the use case when an implementation has detected that the Sensor transition to non-
recoverable from less severe has deasserted.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Temperature
SNMP Trap ID: 0
CIM Prefix: PLAT CIM ID: 0525
User Action:
Information only; no action is required
Service Action:
Information only; no action is required.
• FQXSPCN4000I: Serial Redirection set by user [arg1]: Mode=[arg2], BaudRate=[arg3], StopBits=
[arg4], Parity=[arg5], SessionTerminateSequence=[arg6].
A user configured the Serial Port mode
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0078
User Action:
Information only; no action is required.
Service Action:
Information only; no action is required.
• FQXSPCN4001I: Remote Control session started by user [arg1] in [arg2] mode.
Remote Control session started
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0128
User Action:
Information only; no action is required.
Chapter 2. XClarity Controller events 33
To Next Page
Loading...
