User Action:
Use Storcli or LSA to check if there is any warning or critical RAID event.
Service Action:
Information only; no action is required.
• FQXSPEM0003I: The Log [RecordLogElementName] has been cleared.
This message is for the use case when an implementation has detected that a Log was Cleared.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0200
User Action:
Information only; no action is required
Service Action:
Information only; no action is required.
• FQXSPEM0004I: The Log [RecordLogElementName] is full.
This message is for the use case when an implementation has detected that a Log was Full.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0202
User Action:
Please clean SEL log.
Service Action:
Complete the following steps until the problem is solved:
1. Review PD Steps.
2. Clean system event log.
3. If problem persists, escalate to next level of support.
• FQXSPEM0005I: The Log [RecordLogElementName] is almost full.
This message is for the use case when an implementation has detected that a Log is Almost Full.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0204
Chapter 2. XClarity Controller events 41
To Next Page
Loading...
