User Action:
Information only; no action is required
Service Action:
Complete the following steps until the problem is solved:
1. Review PD Steps.
2. Clean system event log.
3. If problem persists, escalate to next level of support.
• FQXSPEM0009I: The System [ComputerSystemElementName] has generated an auxiliary Log
Entry in Log [RecordLogElement].
This message is for the use case when an implementation has detected an Auxilary Log Entry Event.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0216
User Action:
Information only; no action is required
Service Action:
Complete the following steps until the problem is solved:
1. Review PD Steps.
2. Check the detail information on xClarity Controller web GUI.
• FQXSPEM4000I: The [arg1] on system [arg2] cleared by user [arg3].
This message is for the use case where a Management Controller Event Log on a system is cleared by a
user.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0020
User Action:
Information only; no action is required.
Service Action:
Information only; no action is required.
• FQXSPEM4001I: The [arg1] on system [arg2] is 75% full.
This message is for the use case where a Management Controller Event Log on a system is 75% full.
Severity: Info
42
ThinkSystem SR850 V2 System Events Service Guide