Figure 17. Front operator panel LEDs
Table 16. Front operator panel LEDs
1 Power button/LED (green) 3 System ID button/LED (blue)
2 Network Activity LED (green) 4 System error LED (yellow)
1 Power button/LED (green)
Press this button to turn the server on and off manually. The states of the power LED are as follows:
Status Color
Description
Off None
Power is not present, or the power supply has failed.
Fast blinking (about
four flashes per
second)
Green
• The server is off, but the XClarity Controller is initializing, and the server is not
ready to be powered on.
• System-board-assembly power has failed.
Slow blinking (about
one flash per second)
Green
The server is off and is ready to be powered on (standby state).
Solid on Green
The server is on and running.
2 Network Activity LED (green)
The network activity LED helps you identify the network connectivity and activity.
Status Color Description
On Green
The server is connected to a network.
Blinking
Green
The network is connected and active.
Off
None The server is disconnected from the network.
3 System ID button/LED (blue)
Use this system ID button and the blue system ID LED to visually locate the server. Each time you press the
system ID button, the state of the system ID LED changes. The LED can be changed to on, blinking, or off.
You can also use the Lenovo XClarity Controller or a remote management program to change the state of the
system ID LED to assist in visually locating the server among other servers.
4 System error LED (yellow)
The system error LED helps you to determine if there are any system errors.
30
ThinkSystem SR950 V3 System Configuration Guide
To Next Page
Loading...
