See “Troubleshooting by system LEDs and diagnostics display” on page 29 for more information on the
LED indications.
Configure the system
Complete the following procedures to configure the system. For detailed instructions, refer to
Chapter 5
“System configuration” on page 55
.
1. Set the network connection for the Lenovo XClarity Controller to the management network.
2. Update the firmware for the server, if necessary.
3. Configure the firmware for the server.
The following information is available for RAID configuration:
•
https://lenovopress.lenovo.com/lp0578-lenovo-raid-introduction
• https://lenovopress.lenovo.com/lp0579-lenovo-raid-management-tools-and-resources
4. Install the operating system.
5. Back up the server configuration.
6. Install the applications and programs for which the server is intended to be used.
Chapter 4. Unboxing and setup 53
To Next Page
Loading...
