Lenovo ThinkSystem SR950 V3 - Page 15

Table 2. Events organized by severity (continued)
Event ID
Message String Severity
FQXSPEM4032I Acoustic Mode [arg1] has been engaged. Fan speed limits are in
place.
Informational
FQXSPEM4033I Acoustic Mode [arg1] has been disengaged to allow adequate
cooling.
Informational
FQXSPFC4000I
The bare metal connection process has been started. Informational
FQXSPFC4001I The bare metal update application reports a status of [arg1]. Informational
FQXSPFC4002I System running in setup. Informational
FQXSPFC4003I UEFI deployment boot mode is enabled for NextBoot. Informational
FQXSPFC4004I UEFI deployment boot mode is enabled for NextAc. Informational
FQXSPFC4005I UEFI deployment boot mode has been disabled. Informational
FQXSPFW0003I The System [ComputerSystemElementName] encountered firmware
progress.
Informational
FQXSPIO0000I The connector [PhysicalConnectorElementName] has been
connected.
Informational
FQXSPIO0010I A Correctable Bus Error has occurred on bus [SensorElementName]. Informational
FQXSPIO2003I System [ComputerSystemElementName] has recovered from a
diagnostic interrupt.
Informational
FQXSPIO2004I Bus [SensorElementName] has recovered from a bus timeout. Informational
FQXSPIO2006I System [ComputerSystemElementName] has recovered from an NMI. Informational
FQXSPIO2007I A PCI PERR recovery has occurred on system
[ComputerSystemElementName].
Informational
FQXSPIO2008I A PCI SERR on system [ComputerSystemElementName] has
deasserted.
Informational
FQXSPIO2010I Bus [SensorElementName] has recovered from a Correctable Bus
Error.
Informational
FQXSPIO4002I GPU Board Status was recovered by [arg1] of [arg1]. Informational
FQXSPMA0009I Memory sparing initiated for [PhysicalMemoryElementName] on
Subsystem [MemoryElementName].
Informational
FQXSPMA0022I Post Package Repair Success for [PhysicalMemoryElementName] on
Subsystem [MemoryElementName].
Informational
FQXSPMA0023I Post Package Repair Failure for [PhysicalMemoryElementName] on
Subsystem [MemoryElementName].
Informational
FQXSPMA2007I Scrub Failure for [PhysicalMemoryElementName] on Subsystem
[MemoryElementName] has recovered.
Informational
FQXSPMA2010I [PhysicalMemoryElementName] on Subsystem
[MemoryElementName] is no longer Throttled.
Informational
FQXSPMA2012I An Over-Temperature Condition has been removed on the
[PhysicalMemoryElementName] on Subsystem
[MemoryElementName].
Informational
FQXSPMA2024I Sensor [SensorElementName] has deasserted. Informational
Chapter 2. XClarity Controller events 11