Lenovo TS130 - RAID Configuration

CONFIGURING RAID 100 ON TS130
4
To learn more go to www.lenovo.com/thinkserver
4. In the BIOS Setup Utility, go to the “Devices” tab and select “ATA Drive Setup.”
Figure 2 - RAID 1
5. Set “SATA Controller” to “Enabled” and “Configure SATA as” to “RAID.”
If the SATA Controller is set to “Disabled” then internal SATA drive support will not
be enabled and the option to configure RAID will not be available.
“Hard Disk Pre-delay can be set to “Disabled” (the default).
6. To accept the changes press F10 and select “Yes” when prompted to
“Save Configuration and Exit.”
Configure RAID using the pre-boot configuration utility.
1. If BIOS was just configured for RAID operation, the TS130 will soon restart itself.
Otherwise reboot the TS130.
If two HDD’s are installed, and the SATA controller was configured for RAID mode,
the following prompt will be displayed.
At the prompt, again press CTRL-I to bring up the Intel Rapid Storage Technology
Configuration Utility.
RAID CONFIGURATION