17
5.1.3 Changing the direction of travel:
To change the direction of travel, first set the speed step to “0”. You can
now change the direction of travel:
Press the rotary knob to change the direction
of travel of the locomotive. The changed
direction is shown on the display.
The direction of travel is dependent upon the locomotive, i. e.: For a
steam engine, “forward” means “smokestack forward”, regardless of
the direction in which you have placed this locomotive on the track. If
the locomotive is set to speed step 0, each pressing of the rotary
knob will change the direction of travel.
5.1.4 Emergency off:
Press the rotary knob and keep it pressed
until "AUS"/"OFF" is displayed. The track
voltage is now turned off.
To turn the track voltage back on, press the
centre of the rotary knob again …
… until the locomotive address is displayed
again.
To Next Page
Loading...
Need help?
General