Need help?Do you have a question about the Lenze 492 and is the answer not in the manual?
General| Product type | Controller |
|---|---|
| Manufacturer | Lenze |
| Model | 492 |
| Input Voltage | 24 VDC |
| Output Current | 2 A |
| Protection Class | IP20 |
| Communication Interface | CANopen |
Setting the current limit for the controller. This setting is only necessary when the motor current is lower than the nominal controller current.
Procedure for armature voltage control with IxR compensation, involving setting potentiometers and checking voltages.
Procedure for speed control using tacho feedback, including trimmer adjustments and stable speed setting.
Description of the quick stop function, which decelerates the drive to standstill with nominal current.
Explanation of controller release function. When switch RFR is closed, the controller is released.
Details on controller inhibit function using RSP, setting firing pulses to inverted limit position.
Instructions for inching operation, including wire bridge removal and application proposal.
Indicates controller status like release, inhibit, excessive temperature, bridge changeover, or phase failure.
To Next Page
