Commissioning
Before switching on
7
l 232
EDS84ASC552 EN 8.1
Selection of the appropriate commissioning tool
There are two ways to commission the 8400 frequency inverter:
ƒ Commissioning using the keypad (or diagnosis terminal)
– For simple drive tasks such as quick commissioning of the ’Speed closed−loop
control’ standard application
ƒ Commissioning using the »Engineer«
– For rather demanding drive tasks such as ’Table positioning’ of the HighLine
version
– Supported by online help and accompanying software documentation (software
manual)
I Tip!
Use the »Engineer« to carry out extensive parameter setting and
configuration. The online help which is available for each device and the
accompanying software documentation will assist you.
The L−force keypad can be used for quick commissioning and checking
individual parameters on the controller.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
To Next Page
Loading...
