Lenze ECSEA Series - Page 475

Index 15

475
EDBCSXA064 EN 3.2
J
Jitter, 167
K
Keypad XT EMZ9371BC
− changing and saving parameters, 154
− connecting the keypad, 150
− display elements, 151
− fault analysis, 236
− function keys, 153
L
LECOM, status word (C0150/C0155), 239
LEDs, 236
Legal regulations, 20
Liability, 20
Loading the Lenze setting, 106
Low−voltage supply, 15
M
Mains fuses, 464
Malfunction of drive, 241
Manual field weakening, 362
Manufacturer, 20
Mapping indices to codes, 175
Master frequency input, 331
− configuring input signal, 334
− configuring touch probe, 336
function sequence, 337
− transfer function, 334
Master frequency output, 338
− configuring encoder constant, 340
− configuring output signal, 341
Max. system speed, monitoring functions, 227
MCTRL_MotorControl (motor control), 351
− additional torque setpoint, 355
− adjusting motor data, 366
− adjusting the speed controller, 142
− Inputs_MCTRL, 352
− manual field weakening, 362
− monitoring, 369
absolute value encoder initialisation, 224
− Outputs_MCTRL, 354
− parameterising the angle controller, 360
− quick stop, 361
− setting maximum speed, 357
− speed setpoint limitation , 358
− switching frequency changeover, 363
− torque control with speed limitation, 359
− torque limitation, 356
− torque setpoint, 355
− touch probe (TP)
configuration, 364
function, 364
sequence, 365
MCTRL_nNmaxC11, 357
Mechanical installation, 48
− cold−plate technique (ECSCx...), 55
− important notes, 48
− push−through technique (ECSDx...), 51
− with fixing rails (ECSEx...), 50
Memory
− persistent memory, 377
− retain memory, 376
Memory types, 376
Message, 197