Lenze E84DGFCRFJP User Manual

L
Ä.YR,ä 13564911
PROFINET®
Accessories
Inverter Drives 8400 motec
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Communication Manual EN
E84DGFCRxxx

Lenze E84DGFCRFJP Specifications

General

Category	Control Unit
Protection class	IP20
Input Voltage	24 V DC
Supply voltage	24 V DC
Relative Humidity	95% (non-condensing)

Summary

Safety instructions

General safety and application notes

Outlines fundamental safety measures and general guidelines for the safe use of drive and automation components.

Device and application-specific safety instructions

Technical data

Installation

Mechanical installation

Electrical installation

PROFINET connection

Details the pin assignments and wiring for PROFINET ports 1 and 2 using M12 connectors.

Commissioning

Before initial switch-on

Provides critical safety checks and procedures to perform before powering on the inverter for the first time.

Configuring the PROFINET IO controller

Guides on how to import the PROFINET device description file and define user data length for the IO controller.

Setting the station name

Explains the importance of a valid station name and the methods for setting it according to PROFINET specifications.

Setting the IP configuration

Details the necessity of IP configuration for PROFINET communication and the available methods for setting it.

Setting via the PROFINET configurator of the »Engineer«

Describes the process of configuring IP parameters using the PROFINET configurator tool within the Lenze Engineer software.

Setting via codes in the »Engineer«

Explains how to set IP parameters manually using codes within the Engineer software interface.

Establishing an online connection via PROFINET with the Lenze »Engineer«

Outlines the procedure for establishing online communication between the PC Engineer and the inverter via PROFINET.

Initial switch-on

Covers the final steps for establishing communication, including mains voltage requirements and parameter reading.

Process data transfer

Access to process data / PDO mapping

Port interconnection of process data objects (PDO)

Process input data AI/DI (Slot2)

Parameter data transfer

The acyclic channel (PROFIdrive profile)

Acyclic data transmission process

Reading parameters from the inverter

Details the process for requesting and receiving parameter values from the inverter, including request and response formats.

Response to a correctly executed read request

Response to a read error

Writing parameters to the inverter

Explains how to formulate and send parameter write requests to the inverter, including request formats.

Response to a correctly executed write request

Response to a write error

Error information (error)

Diagnostics

LED status displays

Explains the meaning of different LED states on the Communication Unit for diagnosing PROFINET communication status.

Diagnosing with the »Engineer«

Guides on using the diagnostics tab in the Lenze Engineer software to retrieve PROFINET diagnostic information.

Diagnostic data

Error messages

Short overview of the PROFINET error messages

Possible causes and remedies

Details the causes and remedies for specific PROFINET error messages, offering practical troubleshooting steps.

Parameter reference

Communication-relevant parameters of the operating system

Parameters relevant for PROFINET communication

Details specific PROFINET parameters, their indices, data types, and access rights, including reset behavior.