Lenze E84DGFCRFJP - Port interconnection of process data objects (PDO)

8 Process data transfer
8.2 Port interconnection of process data objects (PDO)
40
Lenze · Inverter Drive 8400 motec (PROFINET® option) · DMS 5.0 EN · 02/2019 · TD23
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
8.2 Port interconnection of process data objects (PDO)
The preconfigured port interconnection of the process data objects is activated by setting code
C00007 = 40: Network (MCI/CAN).
 How to freely configure the port interconnection in the »Engineer«:
1. Go to the Process data objects tab and click Go to application.
2. The Ports tab displays the port blocks MCI_IN and MCI_OUT.
 Note!
The »Engineer« screenshots shown on the following pages are only examples of the
setting sequence and the resulting screens.
Depending on the software version of the and the version of the »Engineer« installed,
the screenshots may vary from your »Engineer« depiction.