Need help?Do you have a question about the Lenze EL 106 PLC and is the answer not in the manual?
Provides essential safety measures for operating Lenze components.
Details supply, buffer, CPU, OS, and memory specifications.
Provides electrical specifications for supply, buffer, CPU, OS, and memory.
Highlights crucial safety warnings regarding input voltage and fusing.
Guides on setting up the IP address and subnet mask for Ethernet.
Details how to configure the CAN interface, node address, and baud rate.
Provides basics for creating a PLC program using Lenze PLC Designer.
Provides programming guidelines, variable types, and addressing for EL 1xx PLC.
Details steps for creating a new PLC program and setting target configurations.
Guides on configuring communication parameters for program transfer.
Explains how to start a project on the HMI and create a boot project.
Guides on creating new POU, task, and program call for CAN communication.
Guides on enabling VNC Server and other servers via Control Panel.
Details communication methods using the CAN gateway function.
Guides on starting the system configurator and adding devices for communication.
Guides on selecting the driver and connecting to the EL100 via GDC.
Guides on starting L-force Engineer and selecting CAN bus connection for devices.
Details assigning hardware number and node address for communication via DDS.
Provides essential safety measures for operating Lenze components.
Details supply, buffer, CPU, OS, and memory specifications.
Provides electrical specifications for supply, buffer, CPU, OS, and memory.
Highlights crucial safety warnings regarding input voltage and fusing.
Guides on setting up the IP address and subnet mask for Ethernet.
Details how to configure the CAN interface, node address, and baud rate.
Provides basics for creating a PLC program using Lenze PLC Designer.
Provides programming guidelines, variable types, and addressing for EL 1xx PLC.
Details steps for creating a new PLC program and setting target configurations.
Guides on configuring communication parameters for program transfer.
Explains how to start a project on the HMI and create a boot project.
Guides on creating new POU, task, and program call for CAN communication.
Guides on enabling VNC Server and other servers via Control Panel.
Details communication methods using the CAN gateway function.
Guides on starting the system configurator and adding devices for communication.
Guides on selecting the driver and connecting to the EL100 via GDC.
Guides on starting L-force Engineer and selecting CAN bus connection for devices.
Details assigning hardware number and node address for communication via DDS.
General| Display Type | TFT LCD |
|---|---|
| Power Supply | 24 VDC |
| Display Size | 10.4 inches |
| Interfaces | USB |
| Communication Ports | RS232, RS485 |
| Protection Class | IP65 |
To Next Page
