What to do if I get a COM BROK error on my Lenze EPM-H520 Touch Panel?
If you are seeing a COM BROK error, the serial data cable between the keypad and the PC might be defective or not properly connected. You should check the Sub D plug connection and replace the serial data cable.
What to do if I get a PR ERROR on my Lenze Touch Panel?
If you're encountering a PR ERROR, it indicates a faulty connection between the keypad and the PC. Check the connection and the cable.
What to do if AASSIIC kkoo11 error appears on Lenze EPM-H520 Touch Panel?
To address the AASSIIC kkoo11 error, check the wiring using code 6666 and verify the parameter settings.
Explanation of pictographs, signal words, and notes used for safety information.
Details on application conditions, environment, and standards.
Technical specifications related to electrical properties and display.
Steps and guidelines for physically installing the keypad unit.
Procedures for connecting the keypad's electrical wiring and terminals.
Procedure for the first power-up and initialization of the keypad.
List of error messages, their causes, and recommended remedies.
General| Display Type | TFT LCD |
|---|---|
| Touchscreen | Resistive |
| Power Supply | 24 V DC |
| Protection Class | IP65 (front) |
| Interfaces | RS232, RS485, USB |
| Operating Temperature | 0°C to 50°C |
| Communication Ports | RS232, RS485, USB |
| Processor | ARM Cortex-A8 |
| Memory | 512 MB RAM |
To Next Page
