About these Instructions
L
51
EDBEPM-H520 DE/EN/FR 4.0
This documentation only applies to the EPM-H520 keypad as of version:
EPM-H520 1B 10
Type
Hardware version
Software version
What’s new?
ID-No. Version Changes
00414160 – 03/2000 TD23 First edition of field test for hardware version 1A
00418420 1.0 11/2000 TD23 Complete revision of series for hardware version 1A
00422472 2.0 01/2002 TD23 Revised edition for keypads of hardware version 1B
00457284 3.0 08/2002 TD01 Change of company name
00479659 4.0 01/2004 TD23 Chapter ”Technical data”:
•
Extended list of features
Chapter ”Appendix”:
•
Extended by information about resistance to chemicals
when using protective foils
All chapters:
•
Fault elimination
!
!!
! Note!
As from version EPM-H520 1B 10 on the HMI Designer, version 1.3 or higher is
required.
© 2004 Lenze Drive Systems GmbH, Hameln
No part of these Instructions must be copied or given to third parties without written approval of Lenze Drive Systems GmbH.
All indications given in this documentation have been selected carefully and comply with the hardware and software described.
Nevertheless, deviations cannot be ruled out. We do not take any responsibility or liability for damages which might possibly occur.
Necessary corrections will be included in the next edition.
4.0 01/2004
To Next Page
Loading...
