Preface and general information
L
54 EDBEPM-H520 DE/EN/FR 4.0
1 Preface and general information
The EPM-H520 keypad can be used to access codes of Lenze controllers, 9300 Servo PLC and Drive
PLC and to facilitate the use of these devices. Controller connection via system bus (CAN).
The HMI Designer is a powerful development tool for creating projects containing the configuration
of the keypad.
1.1 About these Operating Instructions
!
These Operating Instructions are designed to ensure safe and trouble-free working on and with
the EPM-H520 keypad.
!
All persons working on and with the EPM-H520 keypad must keep these Operating Instructions
to hand and observe all relevant information and notes.
!
These Operating Instructions must always be kept as a complete legible document.
1.2 Terminology used
Term In the following text used for
Drive controller Lenze 8200 and 8200 vector frequency inverters, 9300 servo inverters
HMI Human Machine Interface
1.3 Scope of supply
Scope of supply Important
•
1 EPM-H520 keypad
•
1 Operating Instructions
•
8M4hexnuts
•
8M4Uwashers
•
1 Terminal strip, 4-pole for DC voltage supply
•
1 Terminal strip, 5-pole for system bus connection
(CAN)
After receipt of the delivery, check immediately
whether the items delivered match the accompanying
papers. Lenze does not accept any liability for
deficiencies claimed subsequently.
Report
•
visible transport damage immediately to the
forwarder.
•
visible deficiencies/incompleteness immediately to
your Lenze representative.
To Next Page
Loading...
