Installation
L
70 EDBEPM-H520 DE/EN/FR 4.0
3.2.4 Keypad labelling
The keypad can be labelled using a removable label.
$
$$
$ Stop!
!
Disconnect the keypad from its voltage supply before you start working on it to
avoid damage of electrical equipment.
!
The keypad includes electrostatical components which can be damaged if not
handled properly.
1
2
3
4
5
1
2
3
4
MSP
0
h520_011
Fig. 3-7 Keypad labelling
1. Open the housing cover (* 68)
2. Pull out the label
&
for writing
3. After the new label has been written, put it back into the slot
4. Close the cover (* 69)
To Next Page
Loading...
