Glossary
17-1
SHB9300CRV EN 2.0
17 Glossary
Term Meaning
AIF Automation interface (X1)
CAN Controller Area Network
CE Communauté Européenne (English: European Community)
Code For entry and display (access) of parameter values.
Variable addressing according to the format ”code/subcode” (Cxxxx/xx).
All variables can be addressed via the code digits.
FB Function block
Fieldbus For data exchange between higher-level control and positioning control, e.g. INTERBUS or PROFIBUS.
FPDA Freely programmable digital output
FPDE Freely programmable digital input
GDC Global Drive Control (PC program for Lenze controllers - Windows)
RFG Ramp function generator
INTERBUS Industrial communication standard to DIN E19258
JOG JOG speed or input for JOG speed
KTY “Linear” temperature sensor in the motor winding
Target position The target which is to be approached by means of a defined traversing profile.
LECOM Lenze Communication
LEMOC2 PC program for Lenze controllers - DOS
LU Undervoltage
Master A master is for instance a PLC or PC.
OU Overvoltage
PC Personal Computer
PM Permanent magnet
PROFIBUS Communication standard DIN 19245, consisting of three parts
Process data For instance, setpoints and actual value which are to be exchanged as quickly as possible. Usually, this applies to smaller data
amounts which are transmitted cyclically.
With PORFIBUS these data are transmitted via the logic process data channel.
PTC PTC thermistor with defined tripping temperature
QSP Quick stop
Ctrl. enable Controller enable
Ctrl. inhibit Controller inhibit ( = Controller enable )
Contouring error Deviation between momentary position setpoint and actual position. Display for a momentary following error under C0908.
Contouring error tolerance If the contouring error reaches a defined contouring error tolerance, a fault indication is released.
Contouring error monitoring Monitors the momentary following error if the contouring error tolerance is exceeded and releases a fault indication, if necessary.
Slave Bus participant that must wait for the master’s request to send data. Controllers are slaves.
PLC Programmable logic controller
SSC Sensorless control
SSI Synchronous serial interface
TKO Thermal contact / normally closed contact
To Next Page
Loading...
Need help?
General
