Function library
Positioning control
3.4.13 Program sets (PS)
3−89
l
EDSVS9332P−EXT DE 2.0
3.4.13.13 Prg. fct. Repeat function − piece number"
Purpose
l Multiple repetition of the same PS or PS sequence.
9300pos015
Fig. 3−38 Diagram − Piece number − repeat function
Function
l Selection of a no. of pieces from VTPCS under C1328/x.
l Selection of the PS to be branched to as long as the no. of pieces is not reached under
C1229/x.
l Each PS has its own piece counter. C1299/x indicates the current count.
l With every PS cycle the corresponding piece counter is increased by 1, starting from 0.
Afterwards the setpoint and actual values are compared and branched accordingly if the
required no. of pieces has still not been reached. When the no. of pieces is reached, the piece
counter is reset for the cycle and the piece number repeat function is terminated.
l Program reset" resets all piece counters.
l GDC input: Programming" dialog
l Default setting: not active
To Next Page
Loading...