Lenze g500-B - Mechanical Installation; Important Notes; Preparation

Mechanical installaon
Important notes
•
Install the product according to the informaon in the chapter "Standards and operang
condions".
4Standards and operang condions ^ 61
•
The technical data and the data regarding the supply condions can be found on the
nameplate and in this documentaon.
•
Ambient media − especially chemically aggressive ones − may damage sha sealing rings,
lacquers and plascs.
•
Lenze oers special surface and corrosion protecon in this case.
•
Only install the gearbox in the mounng posion shown.
4Mounng posions ^ 18
Preparaon
•
Protect sha sealing rings from contact with solvents.
•
Remove protecon covers from shas.
•
Thoroughly remove ancorrosion agents from the sha and from ange faces.
•
Draw the transmission elements onto the output sha only by using the centering thread.
•
Align the output sha and transmission elements exactly to avoid tensions.
•
Mount belt pulleys, sprockets, or gear wheels as close as possible to the sha shoulder in
order to keep the bending load of the sha and the bearing forces at a minimum level.
•
Tighten all screw connecons with the specied torques and secure them with standard
screw locking adhesive.
•
Check paint for damage and repair professionally.
Mechanical installaon
Important notes
17